Short Circuit Underground Wire Fault Locator , High Efficient Practical Underground Cable Detector

TYHD-2 panel type fault indicator(be called indicator for short below) is mainly used for switch gears for locally indicate short circuit fault and earth fault and also provide wireless signal output .

The principle is micro-controllers with little power consumption, micro-controllers can automatically identify fault signals from short circuit indicator and earth indicator, They can display the fault signals using LED flashing lights on the spot and output the signals by wireless.

Method of installing:

L1 connects with A phase for signal input from optical fiber

L2 connects with B phase for signal input from optical fiber

L3 connects with C phase for signal input from optical fiber

L4 connects with Earth line for signal input from optical fiber

Fault indicate function:

The lights on the L1,L2,L3,and Earth buttons will flash with a an interval of 4 seconds,if the short circuit fault or earth fault occur.This can be reset automatically according to the time delay set before delivery from the factory or manually reset by pressing button of “Reset/Test”.the status of low battery capacity of the indicator can be uploaded by wireless,in the meantime, The indicator will flash for low battery voltage.

Reset/Test function:

1) Reset:

press lightly the “Reset/Test” button slightly, it will reset after all lights on in indicator

2.) Self-checking:

press ““Reset/Test” button, press on L1 and L2 in turn, then let go, after all lights are on at mean time once, the corresponding address lights is on. In 10s, corresponding address lights are on again, then self-checking finished.(indicator current address refer to label number in the back).

3) L1,L2,Wireless function self-checking

4 ) indicator address configure

Function:

1 ) Show short circuit fault and earth fault locally.

2 ) Self-reset ,self-reset time can be set before delivery from factory (The default value is 12 hours).

3) Reset manully /self-test manually is available .

4) address of the indicators can be configured

The method of changing battery:

Take off battery as Chart 1 and Chart 2,then exchange.
Take off the battery and replace the new battery follow the picture1 and picture 2

There is type test report for it, test items as following: